Adjustable Mold Housing Kit for Silicone Mold Making - Leak-Proof Plastic Frame for DIY Resin, Candle, and Soap Molds - Reusable Craft Holder with Free Combination Design for Jewelry & Epoxy Casting

The media could not be loaded. Curing shouldn't take as long as some reviews complain about. Either they had a bad batch, added too much pigment, or didn't mix it completely.Mix it until there is only one green color. No streaks of white. No spots of light or dark green. Mix it for a couple minutes like the instructions tell you and you'll have no complaints.I only used it for the 75ml cube in the photo and I'm sure larger batches will require longer mixing. You'll have over an hour before it shows any signs of setting so you'll have enough time.After properly curing, there were no bubbles or wet spots throughout the cube. There was a tacky feeling like new rubber or silicone as you'd expect. As you handle it, the silicone mold will pick up dirt and oils from your hands and lose its stickiness like tape does. If you want to get rid of the feeling faster, throw some baby powder on it or rub it on your pants. It'll pick up the fabric and lose any stickyness.I used it to make a tab for an AC return vent screen. After I made the mold, I used JB Weld for the copy. Even without mold release, I could easily remove the copy. It's not a complex part but it was able to pick up fine texture details like where the paint on the original was chipped. The silicone is also strong enough to cut open, grab the part, and snap back into place for another copy.Any imperfections in the copy were from my lazy mold making and not getting the bubbles out from under the part. There was some cleanup involved, but a little extra shaking or prep work would have saved me time trimming later.The mold walls are convenient, but use better tape or another method to seal the bottom and sides. The silicone is very low viscosity and will pick up tiny details. It'll also find every little crack and try to pour out.

Fácil de usar

DO NOT BUY THIS PRODUCT unless you want to experience its non leak proof product. Twice it leaked and twice I had to clean up the mess from it leaking the entire silicone out of it. I lost projects I was working on because of it. I lost ttme and money because of it

For a product that states a 1:1 mixture you might think the two parts would have equal amounts, which they didn't, in both purchases I've made.The product itself does work fine, just mix longer than you think you might have to and you shouldn't have any issues.The picture showing food grade and the note saying not for use in contact with food should be clarified to greater extent!

Great product still working on the pattern to pour in to create the silicone mold.

Bought 2 so I can make bigger shapes! I love that i can make my own sizes with 1 product.

This mold was not easy to assemble even with the little clips. Had wanted this item for a very long time but when it came, I was very disappointed!! The mold is a hard plastic and the pieces do not interlock well. I'd return it but the process is a hassle.

Quality is good & all the parts needed for a mold to be poured