ROBERTS Palette Quick-Repair Putty for Wood, Laminate & Vinyl - Light Wood

Works exactly as designed. Couple of scratches on my stairs from an appliance company scratching up our LVP flooring when delivering our new appliances. No mixing needed. Easily applies and dries quickly. So far it’s held up to washing the floors.

Believe the reviews! This stuff is fantastic. We were DYI refinishing our oak hardwood floors. There were two areas we had to remove and replace boards. We also had to do some fill in of little areas after the sanding was done. In the area we replaced boards there were a few small gaps. I tried two other products that just didn’t seem to look nice. In frustration, I read the reviews on this product and decided to give it a try. It worked perfectly! Color match was better than the completion. It dried quickly and it looks nice. It was very easy to work with.

It's a decent product. I don't know if I was using it wrong, but, I tried to wipe the excess and it looked like a hot mess for a couple of days. The color matches my floors perfectly and applying it was easy. It did eventually harden and looked better but the excess stayed on the floor for a couple of days and eventually was gone. It's been a couple of weeks and it's still holding up. I did try it in other places and I didn't have the same issue with the excess. I would recommend to just make sure you follow the directions. It does have clear instructions and cures in the time it says that it should when applied correctly.

this stuff works good! had to use where separation occurred between flooring slats and it hardened into a durable walkable surface! after couple months had to use again and the product is still pliable and usable!

I wish I would have taken a before and after of my floor because the results were dramatically positive. I purchased the light gray and grey together due to the pattern and colors in my floor and it worked amazingly. Not only did it perfectly seal the tiny cracks, it blended so well. Very easy to use, doesn't make a huge mess and cleans up well.

It’s ok, it did its job to fill the hole, but the color didn’t match the photos on Amazon. So it turned out lighter than I would have liked.

Contractors didnt lock certain areas of my LVP properly so it started to chip and peel in those areas. I bought the Tan color for my LVP from Home Depot in the color French Oak Alturas by Malibu Wide Plank. It’s pretty much a perfect blend. I definitely recommend doing thin layers if it’s a big chip or crack for better durability and preventing cracks. If it’s a high track area though, cracking is going to happen.

This product comes with ZERO instructions and the Amazon page has no instructions. You will need to ask AI how to use the product, which is a bit frustrating. But once you get the instructions, it's pretty easy to use and dries quickly. The color match is good and the finish feels durable. The texture is a bit like melted chocolate. It dries quickly and it comes with a lot of product. Here are the instructions I received from Amazon's Rufus AI: Basic Application Steps: Clean the area - Remove any loose material from the gap or scratch Apply directly - Squeeze putty straight from the tube into the damaged area Level and smooth - Use a putty knife or your finger to spread evenly Remove excess immediately - Wipe away excess with a dry paper towel before it dries Let cure - Allow to dry completely (dries fast, typically within minutes to hours) Important Tips: Apply in thin layers for better durability on larger repairs Work quickly as it dries fast Don't let excess sit too long on the surface - it can be difficult to remove once cured For best color match, you can mix different shades