Aoerzn Premium Battery Terminal Connectors for Nissan, Positive and Negative 1 pair, Good Contact, Corrosion Resistance, Fits For 243407F000 243407F001

I had bought similar quick disconnect terminals on Amazon before and they worked fine. This one was an absolute disappointment. I had barely started to tighten the main fastener and it snapped like a dry twig. Unlike typical lead battery terminals this product has zero give and is very brittle. Will be returning it and taking a chance on one of the previously purchased Chinese junk.

These worked great for a car stereo install. I had to cut and trim a couple eye terminals to fit on the bolts, including the stock battery connector. But now I feel the battery cables are much better secured than stock. You'll want to wrap the handle and main portion of the positive side in some tape, to prevent shorting against things.

Good fit, inexpensive, decent quality, easy to use. Doesn't hold as well as I had hoped. 4 of 5.

These were jus what I needed for my Kubota RTV. Modifications to the existing cables are required because Kubota has proprietary cables that they sell with the battery terminals attached. Rather than cutting off the old terminals and crimping on new lug terminals, you can bend and cut metal off the old terminals making lugs out of the old terminals which are most likely broken if you are replacing them. They will then fit in these new battery terminals in the same manor that they were on the old terminals. The holes in the old terminals will be too small for the bolt provided for cables on the new terminals but they fit nicely on the bolt that squeezes the terminal together which is how Kubota manufactured their cables to start with.

Buena calidad son muy practica

Poor design. For the clamp bolt it spins when attempting to tighten the nut. For the clamp, there is not enough clearance around the 10mm nut to use a box end wrench, socket, or nut driver to tighten the clamp. Between the two flaws, it would not tighten. This is not quality. Save time and frustration by spending a little more. I will buy genuine Toyota clamp.

I did install it and I suppose it will last about as long as any battery connector. One issue is that it won't fit as supplied. Both the positive and negative connectors have plastic that goes under it and contacts the battery top or the felt protector that is also supplied. The problem is that the way the plastic is attached to the connector makes it hard to impossible to tighten the connector to the terminal as it prevents enough compression around the terminal. And because of the added height of the plastic it also prevents you from pushing it as far down on the terminal as it needs to be for a tight fit if you also use the felt protector. I solved this problem by cutting the plastic where it is held by the tightening screw and pushing it out of the way. You can see it hanging down in the picture to the left of the battery. Now, if I had not used the felt under the connector it would have fit but still caused problem in the tightening screw, but using both the felt and attached plastic used too much room. A very small problem but the design should have accounted for it. Secondary problem is that the bolt used to tighten to the terminal will slip as you tighten it. The head of the bolt is supposed to be held by the connector not to turn as the nut is tightened but it turns anyway. Just means I have to use a second wrench to hold it.

My old terminals were stripped out and looked like they were about to snap in half, so I ordered these! I disconnect my battery every night due to a fuel pump issue on my ‘95 Geo Metro, and this made it 50 TIMES EASIER! No tools required, just pop the hood and boom, they’re off (or back on)! Would definitely recommend these to anyone that either disconnects their battery often or just needs some fresh terminals! Super cheap too!