Stanley Trigger Feed Dual Melt Glue Gun, 0-GR25, STA0GR25, Multicolor

Quality is good. Two heat modes also useful. Highly recommended

Very good product with dual power switch

Good, well made product.

Works well and it is usefull.

Good

GLUE METLS AND STRUCK INSIDE, NOT COMING OUT, TOTALLY WASTE OF MONEY

After almost one month of little use, it stopped working. I checked the inside, I found glue had melted inside and covered all internals which made it completely unusable and had to throw away. Unfortunately, waste of money!!

I cannot give it a single star . I plugged in , the nozzle got hot but when I use the trigger there is not dripping of glue . Totally useless I want to return it .

this glue gun works fine. The holder is good as well. Had no issues with it

Ottimo prodotto consiglio

Très bon produit, très pratiques. Seul bémol : sa prise est faite pour l’Amérique du Nord... vous aurez besoin d’un adaptateur pour l’utiliser en Europe. Les recharges de colle sont à 11mm.

***UPDATED 15th September 2012*** Upgraded to 5 stars due to the versatility of glue guns in general. Latest repairs include the 'flapping' sole of a pair of carpet slippers - great result; found it best to apply liberally/generously and work fast to get good adhesion. That cost me one glue stick (about 17 pence for Stanley, or about 10p for Silverline). Any excess/outflow can be neatly trimmed of with a sharp craft knife. Also repaired an exercise bench, the plastic end caps kept popping out - not any more! Be careful to avoid contact with hot glue oozzing out of a repair job. Regarding the inadequate stand, the base of the stand could be made wider/more stable by hot gluing a suitable piece of plastic to it. Original Review: Feels well made, heats up within the 3 to 6 minutes stated in the instructions, quite controllable flowrate of hot glue. The end nozzle is covered with a heat resistant thermally insulating material (maybe PTFE?) presumably to help prevent burning your hand. Dribbles a few beads of glue from the end nozzle when resting on the stand, but not excessively. Put it to use straight away to a) help secure/prevent wobble where wooden handle enters a plastic snow shovel, b) help secure/prevent wobble where wooden handle enters a broom, c) repair an RC model, d) help secure low voltage wiring inside a RC model (first tested to ensure does not damage the insulation). The declared wattage (power) is somewhat confusing. The Amazon description states 40W, however if you look at the photograph, it says 80W on the side of the gun. OK you say 40W low, 80W high .....that's what I thought. However, on the other side of the gun itself it actually states 25W? Anyway, it works well enough (I only tried it on the High Power setting). Looses one star due to the inadequate stand, which is not really wide enough to hold the gun securely in the upright position. Also the mains lead is a bit too short.

This glue gun works great. It gets hot fast and I’ve used it on many different projects. I highly recommend this.