Toyota Genuine Parts - Rubber, Wiper Insert (85214-0E050)

Appears to be new rubber and fits and works perfectly once you get it installed. But it is JUST the rubber piece , so you must carefully remove the old rubber blade, fish the two wire side pieces out of it, install the two wire side pieces into this new rubber blade, and then carefully reinsert the whole assembly back into the wiper arm. Make sure that the prongs on the wiper arm are in the correct groove of the rubber blade because if they pop out , they could scratch your windshield !

This item installed quickly on my 2013 Prius 3 and restored the wiper to "new car" efficiency. Buying the wiper inserts is more cost efficient than buying new blades and takes little effort. Simply slide out the existing insert, being careful not to bend the metal inserts that surround the insert. Once removed, carefully check to see where the two metal inserts are located on the sides of the existing rubber wiper blade insert. After that, I found it easy to simply start at one end, slightly loosen my grip on the removed wiper blade assembly to permit one end of the new rubber insert to be substituted between the two metal pieces, allowing the old rubber insert to fall away. Then, I simply guided the metal inserts into the balance of the rubber inset. Once you have the metal pieces in your new rubber wiper blade insert, simply slide the whole assembly back into the wiper blade. For the passenger side wiper, I removed the blade from the arm for convenience. The other two were easy enough to do while in place. Its more complicated to describe then it is to do. Plan on about 3 minutes per wiper.

I've bought these several times over the years and always satisfied for 1-2 years of durability. Never toss you OEM wiper blade holder so you can use refills.

El artículo enviado es un remplazo de mala calidad no un original como ellos indican, no cumple con lo necesario ya que no se puede instalar

Like the flexibility of the rubber to clear objects stick on windshield !

Fits our 2010 prius perfectly! These are just the inserts or blades and not the full wiper assembly. Don't forget that you will have to save the metal pieces from the wipers when you replace the rubber inserts/blades. In total, changing both front wipers and the back wiper blade, it only took about 5 minutes to replace the blades.

Why did you pick this product vs others?: OEM Fit: needed some work to take out old blade and install new one. Ease of removal: Not easy

Perfect OEM fit for a Gen 3 Prius rear window. (2010 to 2015). This is the way to go if your blades are worn out. Don't replace the entire assembly with a low-quality aftermarket part. Buy the authentic OEM part -- and you just need to replace the thin rubber blade. Win-win.