5PCS LCD Screen Protector Film: Scratch-Resistant High Light Transmittance Protective Films for Phrozen Sonic Mega 8K/Mega 8K V2/Mega 8KS LCD Resin 3D Printer,15″

Fantastic!!

This comes with a little bubble remover spreader which I didn't see until after the protector was installed. The protector that comes on the Mega 8K S is actually slightly smaller than the screen, so any spills on the edge can get under the glass. This one is larger all the way around so that can't happen. The thickness is just right so I didn't even have to relevel. The clarity is great. No complaints.

A definite "must have" with resin printers. Can prevent ruining your printer.

This 5 piece kit of screen protectors comes with all the necessary products needed to install them. It comes with plastic scraper to work the bubbles out from under the screen protectors, screen cleaning wipe, a microfiber cloth, and a tack clot to remove dust particles. It fits my Saturn 2 8k just fine. I don't see a change in my prints with it installed. I did have to re-level after installing it, which made me a little sad as I've done close to 100 prints without re-leveling it prior to installing it. My biggest problem is that it doesn't come with an instruction sheet. Not everyone will know how to install them and may not do the ordering of them. Sure they have instructions here on Amazon, but nobody wants to have to pull up Amazon while installing it if they don't know.

Perfect hard great screen protector fit perfect

I ordered this screen protector because it was advertised specifically for the Phrozen Sonic Mini 8K / 8KS. Since the listing clearly stated compatibility with the 8KS, I expected it to match the factory-installed screen protector dimensions. When I went to install it, I immediately noticed it was oversized — approximately 10 mm too large on one side and about 7.5 mm too large on the other compared to the original factory protector. I carefully placed it down to test the fit, and that’s when it became obvious it would not fit properly. When I removed it, one protector was essentially wasted in the process. The seller offers different sizes for various popular 3D printers, so it’s reasonable to assume that a product labeled “Sonic Mini 8K / 8KS” would be pre-cut to the correct dimensions. Nowhere in the listing does it state that trimming is required. After manually trimming the protector myself, I was able to install it, but I was very disappointed that it was not properly sized as advertised. If you purchase this, be prepared to measure and trim it yourself. I’m giving it a three star because it was reasonably priced. Installation was a little difficult because the tool to remove the bubbles was wider than the screensaver so it didn’t lie flat and I couldn’t get the bubbles out at the side edges, worked fine getting the bubbles out from the top and bottom. I recommend they sell a screensaver that matches the printer specs and also a narrower tool to remove the bubbles.

Description said compatible with Mars 5, as I was about to install it I check the fit and there is a big chunk of the screen unprotected

Used these on my Humminbird fish finders as a screen protector. easy install.

Mühsam beim installieren aber gut

Excellent just what I wanted

Seems to be doing its job. Hopefully it protects the screen from any resin that spills through

L'article est conforme. Parfaitement adapté a ma M7 max

This was not as advertised. The screen protectors I received where 5 1/2" and way too short for the Mono 4. Do not purchase. They look like generic, non-descript cheap screen protectors.