Wifi Tuya RFID Door Access Control System Kit IP68 Waterproof Access Controller Touch Keypad + 180KG Electric Magnetic Lock + K80 3A Power Supply + 15pcs 125KHz Keyfobs

Does not work do not buy ! Piece of crap !!!!

Excellent product i have not tested with Water proofing or anything else but the Magnetic lock is quite good its strong and it works fine i know its technical to understand its wiring but trust me its not that hard you just need to read their manual and their Manual is easy to understand

Touched pad became unresponsive after 4 months of use. Wiring diagrams were not correct. But thanks to other reviews its possible to wire it up and it does work, until it became unresponsive. Thankfully i had additional RF control installed, so at least we van open the door, butnif we were left to the controller/touchpad, we would have been stuck. Actually first time it became unresponsive i had to rewire which helped for 2 months, now buttons dont work and it doesnt recognise the blue tags anymore. Wo you cant open the gate.

I rigged up a small test station to put everything together, and it all works once you figure it out. Just be warned — the instructions are a bit poor, so it took some trial and error. But I managed to get it working fine, and now I just need to fit it in its intended place… that’s a job for another day! Overall, decent kit once you get past the setup.

Not sure what’s up with the unit as all seems to work other than the lock retracting

The system on the whole works but the instructions are poor, the wiring is: push= blue from keypad and one side of the door open switch,GND=black&purple from keypad and other side of door open switch,+12V= red from keypad,-COM= black (mag lock),+NC=red (mag lock). Also, when you code the RFID you need to turn on the search first then SWIPE the tag across dont leave it there as it wont always read properly. Other than that it does work and the app is relatively easy to use

I didn't buy mine here but found this page looking for good instructions. What I found here allowed me to get it working with tags, password and fingerprint. So far, pairing with the app over wifi has defeated me. I'm not sure how to set the panel into pairing mode, AFAIK, it's *999999#74# but * gives me a doobell sound and it doesn't seem to go into pairing. Any suggestions welcome. It seems pretty good for the money but it will require persistence the install. I recommend some silicone sealant as I would rely on the water resistance

Works as it should good piece of kit highly recommend. Wiring instructions could be better