8pcs Joysticks Replacement for DualSense PS5 Controller, 3D Analog Sensor Wheel Thumb Sticks Joystick Rocker Module Replacement for Playstation 5 Controller

Great analog replacement. Do require soldering

They work well.

Very good spare parts

I replaced these pots in 3 controllers. It fixes drift, but comes with it's own issues right from the manufacturer. Some work, some don't. For those of you having issues replacing, due yourself a favor, buy low melt solder, flux, and desolder wick. Makes easy work of this. Apply flux to pins, add low melt solder being mindful of not staying on one pin too long. Move low melt to all pins and keep moving in a circular motion keeping board hot. The pot will fall out. Clean with ipa, put down fresh flux, apply wick to board to clean holes followed up with another cleaning of ipa. Install new pots, flux pins, and resolder again not staying too long on the pins to prevent burning eyelet and ruining the board.

Some worked well and I had like 3 of them that already had some major stick drift. Even after useing a 3rd party software to re calibrate them. Glad I got 8 of them.

I took the guts out of part of this and it fixed the stick drift in my PS5 controller. I later got drift on one of my XSX controllers as well and swapped out the guts with this and it fixed it just the same. Both Sony and Microsoft seem to be using the same internal parts. Completely worth it to fix both of my controllers and I still have several guts left to fix 6 or so more controllers if I need to.

Worked to fix the stick drift on both my PS5 controllers. And have extras to fix in the future.

I replaced both my joysticks in my controller. I went online to calibrate them for center and circularity and they calibrated fine. Which the circularity actual came out better than the new controller I bought. But after moving the sticks around a bit and pushing down on them, the left one would just jump off to the right. I pushed/moved the stick around a bit and it would go back to center. So I replaced the joy stick again and all test where fine. Well, until about a few hours of game play and the left stick would just start going the the right again. Testing online again, I could see the left line jump off the the right just for a bit and come back to center. I could not get it to stay there, at the right like the 1st joystick. So I just gave up on this controller and bought a new one. The board installed was a BDM-030.