Land Guard Galvanized Raised Garden Bed Kit, Galvanized Planter Raised Garden Boxes Outdoor, Oval Large Metal Raised Garden Beds for Vegetables…

Llegó incompleto, no se puede usar, faltan piezas,

I was surprised at the light weight of the units. Both 8'x4' came in a single box weighing 33#. The light weight aluminum panels made them easy to handle and assemble. Assembly was straightforward. The panels are 2' long and have 4 holes pre-drilled in each end. These holes were accurate and smooth as were the edges of the panels. While I wore light gloves, there was little opportunity for cuts or splinters. The kits came with packets of hardware, nuts, bolts and connectors for the center support rods. Happily the nuts and 1/2" bolts were all galvanized which should improve their longevity. The one complaint I have is they did a poor job filling the hardware packets. There were twice too many connectors, far too many bolts and not quite enough nuts. This wasn't a big deal, they just wasted some of their own money. The nuts and bolts seemed of good quality. Only 1 bolt out of 100 or more was defective, all the nuts screwed on easily and the galvanized coating was very even. I bought 2 sets (4 raised beds) with the notion of stacking them to make 2' tall, raised beds as my 77-year-old back complains loudly when bending over for a time. This worked quite well. I ended up buying 10 more 3/4" bolts as the 1/2" bolts that were supplied were too short to get started on some of the curved panels which were 4 layers thick where I spliced them together. The longer bolts saved my day! If you decide to do as I did and stack them, don't build the two units and then try to join them together as I did on my first set. It was exceedingly difficult. When I built the second set, I built the lower half, then attached the 2 straight side panels on each side, complete with their support rods. Then I began adding the curved end pieces one at a time. Because the diameter of the curve was increased slightly, some of the holes didn't match where the two sections joined and I had to re-drill them but that was only needed on 2 or 3 holes. It took me about 2.5 hours to completely assemble the second 4'x8'x 2' raised bed. Tools needed are simple. An 11mm open end wrench, A Phillips screwdriver and an electric screwdriver (very helpful as there are many bolts) and a 1/4" drill bit if you stack them as I did. BTW, the photo shows a completed unit sitting on a 24'x 4'x 2' raised bed I built out of treated lumber. It cost over $1000 3 years ago compared to $270 for these beds. PS, It remains to be seen how well they hold up when filled with dirt.

Schroeven zijn van mindere kwaliteit die het in elkaar zetten niet makkelijk maken 🥲😅

Es muy fácil de montar en una o dos jardineras . Ligera para mover y resistente para proteger plantas.

Beautiful simple garden beds. Easy to assemble.