LE LEMATEC Inline Air Dryer & Desiccant Filter for Paint Spray Gun

I have bought 5 of these filter (now 6 with this last order) and i can tell you that they deff work. My area is very humid all the time so getting the water out of my air line before painting is not easy...i usually have one of these on my tank and one inline before the spray gun.....i change the beads damn near every time i spray now.....but eventually after about 3 months the housing will crack or start minor leaking then eventually its no good.....i will say keep any chemical like acetone away from them because it weakens the clear plastic and causes it to snap (don't ask me how i know) but if you need a quick fix these will work for a little while

I gave this product 5 star because it does do what it says, however as I'm sure many of you as myself try to save a buck and try to use things hoping for results other than intended, that being said the picture on the package shows the use of it before a paint gun, but the add also shows it on the air compressor outlet as well, let me tell you if you use it for a paint gun I'm sure it should be fine but also if you have no other filter/dryer in place this will not last through one cycle of the air compressor, I live in FLA used this on a cold day [60] yeah that's cold here, anyway compressor was completely drained, closed the valve and used a air tool for maybe 10 minutes total and beads were completely pink, I bought two of these so swapped it out for the other one, used my air blower to blow off the debris I had caused from the air tool and the 2nd one was pink before I got things blown off, was hoping for more is all, ya gonna have to spend a couple hundred to get a good system, just can't get around that

This is a great Jeep alternative to an expensive air dryer. I use it for HVLP and plasma cutting. If the silicone is pink, just microwave it for a couple of minutes and we’re going again. Also replacements occur is relatively cheap and could be bought and bulk.

These are very nice and sturdy and do not leak, very good for keeping the air dry and you can easily see the desiccant silica gel to know when to regenerate the beads.

Using it on a plasma cutter - fitted between the compressor and the standard water trap that the plasma cutter came with. First use, half of the desiccant turned pink, so that tells me that it's doing its job. No moisture ended up in the water trap. Would suggest getting a bag of desiccant at the same time, as it's cheap enough, and you'll probably need to change it out fairly regularly - which is very easy to do.

I had 2 of these arrive with a crack at the bottom, contacted customer service, and they immediately addressed the problem. Within a few days I had 2 brand new filters. They even sent an extra filter expedited because I was in need of one quickly. Best customer service I have had on Amazon thus far. Product itself works great, using these as secondary filters for blast cabinets and primary for a plasma cutter.

Started leaking after 3 uses

Works great! Yeah ,”turns blue to pink too fast” ? What makes it turn pink? Water ! It works as it should . You have too much moisture in your lines if it turns too quick for you.., it’s not broke ,your filtration system is

Great product and works better then my previous air compressor dryer which used less desiccant beads and more changing of beads. The dryer filter is well made and holds quite a few beads. Overall I’m pleased with this product and would recommend it.

Funciona bien y la calidad es buena, solo hay que manipularlo con cuidado al instalarlo, no requiere mucho torque y cuando se carguen las bolitas desecantes hay que asegurarse que no interfieran con el sello y que no queden muy apretadas

Thanks

Top Verarbeitung

It is good to use but glass case brekas easily and cannot be repaired or changed.