Chanzon LED Driver 600mA (Constant Current Output) 30V-57V Power Supply | (Input 100-240V AC-DC) (10-18)x3W 20W 30W 36W 45W 54W Lighting Transformer Drivers for High Power COB Chips (Plastic Case)

Out of the several I bought, one didn’t work initially, but now everything is working fine. Make sure to read the manual carefully

Installed the unit on the light and it worked perfectly.

Works but has a 1vse one delay when turning on switch

This works well as a replacement for the faulty factory driver, that only lasted a little more than a year. However, it is nearly too large and too tall, so I had to carefully position it and use hot-melt glue (applied similar to a bead of caulk) to secure it to the housing. I also spliced in the circuit board connector making certain that polarity was correct. Then tested performance prior to wiring and mounting it back to it's original position. This is a good value - saved me paying 2-3 times the cost for a new light and satisfaction of recycling rather than adding material to the landfill. The original non-working driver will go to the local e-waste collection site. Hopefully, this replacment will last much longer than the original! I'll report back here if it doesn't last! See photos for specs on the old driver compared to the new driver.

Replacing them a couple of times a year.

I'm able to control this driver using a relay that is activated by a Raspberry Pi Zero 2W. The driver lights up 17 LED bulbs at 3 watts each. However, I'm a little worried about the lack of grounding. Relay: https://www.amazon.com/dp/B00LW15A4W?th=1 LED Bulbs: https://www.amazon.com/10pcs-Purple-Ultraviolet-Bulbs-365NM-370NM/dp/B098JZ5SLC/?th=1 Heat Sinks: https://www.amazon.com/dp/B07GZMSKW4 Thermal Glue: https://www.amazon.com/dp/B072MSXHJD (to connect LED chips and heat sinks) The amount of power makes the LEDs heat up rather quickly, so I cycle the power on for 3 minutes, then off for 7 minutes.

Since the price was just right, I purchased it to replaced my old driver a month ago and it was easy to install.

The only reason I did not give it a 5 star rating is because it hesitates for a second before it lights up. I have dual vanities with identical lights and one of them the LED driver went bad. Part model:A80Z224. Could not find a replacement LED anywhere. I tried a Lowes replacement but all it did was flicker and never fired up. The light was purchased at Home Depot and to replace the part was a fraction of what it would cost to replace the entire light. Eventually I’ll get over the fact that the one light hesitates compared to the other light in our dual vanities.

Thought I was going to trash my LED bathroom vanity light fixture that I really liked as the driver suddenly failed. Pleased to find this unit that was easy to install and works great. Took a little extra time to receive but well worth the wait. Hope it outlasts the original driver.

Brilliant. The company who originally manufactured the lights at 36v changed their market position and moved into solar. So when the driver failed this one brought back the bright ceiling light. I removed the connector from the old driver and wired to the new one do it could connect with the led lamp

Needed one of these to replace a failed unit in a fairly expensive light fitting and it did the job perfectly to the great pleasure of my son's family. Good product, very good price and great delivery. Thanks.

It works well