Elenco TL-3 BNC to Minigrabber Test Lead Set, Black

Great test leads! I use mine mainly with my signal generator, which has a BNC out, and the minigrabbers allow me to put my test signals nearly wherever I please. The minigrabbers hold tightly yet the tips can be prone to bending (as with any minigrabbers, not just the ones on this cable) and the BNC connector was very tight at first. However, after 15-20 uses or so, it has loosened up a bit, but still provides a solid connection. NOTE: I've seen some reviews where people have been using these as an oscilloscope probe.....with some scopes, and under certain circumstances, this would work proficiently, however, the cable isn't shielded like a real scope probe (or at least not shielded as well as a scope probe) and doesn't contain the input resistance, capacitance or the voltage divider a genuine scope probe does. Most scopes are designed with all of those factors in mind, and are necessary to get a good measurement. Just a word of advice!

Works as advertised! These are very handy and easy to use and adjust. A small dpress on the top and a small electrode hook pops out to attach to a circuit or a wire. Great if you are tired of holding one end on all the time! These are adequate, very handy for searching for problems on a board and a very good buy for what they are. They are delivered from China so there is a few weeks wait for the delivery as I recall.

This item was purchased to connect to my BK Frequency counter that I purchased to align my personal cb radio(s). This item works as it should and I am now able to confirm, check, adjust my cb radio to within original factory specifications. I wish I would have purchased another one just like it except a little longer in length, but it still works like it should. Yes, I would purchase another one except the next one I would like to have is a longer cable length.

Good add on for kit

I have one piece fo test equipment that has the BNC connector (other than the oscilloscope which has the standard leads). I keep finding that I need to hook it to small wires on breadboards - and this set of leads fits the bill exactly. The BNC side is very sturdy. The small clips are not the very high quality clips that you see on the ends of HP gear or similar high-end test equipment - you may need to take some needle nose pliers and adjust them for better fit. The metal in the clips is 'soft' and I can see that they will eventually succumb to fatigue under heavy use. That being said the clips *do* work, they hold on to the wires where you put them, and with care they should last a few years of moderate use.

They work fine .. good price ... : tkjtkj, mech.eng., m.d. My criteria: 5-star: does the job well, with extra advantages 4-star: does the job well 3-star: helpful but doesn't accommodate all needs that one would expect 2-star: sketchy performance at best 1-star: they showed up for evaluation

Good item, thank you.

If these are anything like my first set back in engineering school, they should last forever. The fit and finish of assembly are high quality and I don't see any obvious weak points that would require repair after a few years of rugged use. Very useful and highly recommended for any electronics bench.

Decent quality, so far so good. Time will tell.

ESTOY RETOMANDO EL HOBBISMO DE LA ELECTRÓNICA, RENOVANDO, MI EQUIPO Y MIS DIFERENTES REFACCIONES Y ESTE CONECTOR ES MUY ÚTIL.

ok

dont expect the world from these cables but for the price I could not assemble one cheaper or batter

As advertised, flexible cables