(20 Discs) - Fixing Wall Plugs Fast! No Need to Fill or redrill.

This works great and is so simple to use. If the hole is pretty loose use two patches on top of each other instead of just one. Who ever came up with this is a genius.

We had a sagging double curtain rod over the picture window for about 2 years. It's been changed out, re-positioned, rehung, and re-leveled approximately three times over the past 10 years. The drywall is old, thin, and had a crumbling hole that I could fit my finger into right where the center support needs to go. I put three of these wet discs around the anchor plug. NOTE: PAY ATTENTION -- make sure the screw and plug size will fit the holes of the thing you're hanging. For example, my double curtain rod support would only accommodate the little screw that came with it. Since I couldn't go with a larger screw, I used more WET N SET discs and a smaller anchor plug. A bigger plug would have filled the hole better, but would have been too big for the required little screw. I dipped the discs 1 at a time and wrapped around the anchor. It looked about as big as the hole, so I gently hammed the plug into the decaying drywall hole. Then I wiped the little drips off the wall and waited a few minutes. I really didn't think it was going to work. I screwed the curtain rod support back in place, and to my delighted surprise, IT WORKED!!! IT'S MAGIC!! SORCERY!!! The middle rod support is now the strongest point of the whole darn curtain rod setup. I did this over a year ago, and it's still just as strong as ever. I've washed and rehung curtains more than six times since then, and it's holding up great. I wish they would sell a smaller set for half the price because I don't know that I'll need all these. And I'll probably lose them before I do. Anyway, worked great. Try it! UPDATE: I've used them A LOT!! Most recently for the latch on our privacy fence. The wood is a little old and splintered and the latch gets slammed several times a day. The screws have loosened and fallen out a few times only to be replaced with bigger, longer ones. Well, you can only go so big and so long before you go all the way through. Just before that happened, I used the discs and a plug. That latch is not going to go anywhere! It is sturdy, tight, and strong. This stuff is great. Well worth the price. Think of it as an investment in your peace of mind.

Worked great for one thing and then didn’t work so great for another but overall a decent product.

Worked well to fill a hole and reuse that spot for an anchor.

Both my towel ring and toilet paper holder were starting to pull out of the wall, and I didn’t want to deal with patching and re-drilling. I tried the Wet N Fix wall plug repair pads, and they worked perfectly. I just wet the pads, pushed them into the holes, let it dry, and reinstalled the screws. Everything tightened up nicely, and both fixtures are now secure and solid again. Such an easy and cheap solution that saved me a lot of time and frustration. Highly recommend if you have loose anchors or screws that won’t grip the wall anymore.

This is a great, affordable product that does what it says! I had a badly damaged hole from two drywall mounts that were about 1 inch apart. The integrity of the drywall was so badly damaged I couldn't replace the drywall mounts until I used this product. It was great, and it saved me a lot of time and potentially a costly drywall repair. I strongly recommend this product for its intended purpose and in my case...even more!

This did not work for me but I think the hole in my wall was just too big. Also, important to note you cannot use it with self drilling drywall screws. If you are like me and the hole is too large try a snap toggle bolt. Super easy to install.

This stuff most definitely works, and the repair I did is holding strong with zero issues - but I found out there is a learning curve after trying it out in the same place 4 times! In order for it to withstand the force from the screw, you need to let the Wetnfix AND your drywall dry out almost completely, otherwise your anchor will just pop out again when you try to get your screw in. Don't follow the directions and only wait the 3+ minutes, because it will absolutely not work and you'll end up making the hole even bigger. For reference, I let mine dry about 8 hours and because the hole was so big by my 4th attempt I had to use 3 discs. Hopefully this helps others who had the same issue as well with this product.

Bardzo szybki i łatwy sposób na mocowanie luźnych kołków w ścianach.

This product works really well. For a long time I have been struggling at home with crumbling concrete walls when trying to mount shelves etc. but this have now saved me stress and frustration. Highly recommended.

Works great excellent

A week ago I was fixing shelves to an old wall, plaster over masonry, and two plugs ended up right in the mortar between the brickwork. The whole thing turned to dust as soon as the drill touched it, and my hole was immediately 4mm too wide. Ordered these, they arrived yesterday, and now those shelves are up and holding beautifully. I suspect they aren't as strong as the ones going straight into brick, but they're plenty strong for the task and honestly far more secure than I was expecting! These really are a great option to keep in your toolbox, I think. I hope I never need to use them again, but I'm glad to have them handy.

Eenvoudig en doet wat het moet doen zonder veel problemen