Maxracing 1.5" Leveling Lift Kit Compatible with 2007-2024 Sierra Yukon XL1500 Avalanche Silverado Suburban 1500 Tahoe

Soulever l'avant de mon nouveau GMC sierra 2024, bon produit et de bonne qualité, le point négatif sont seulement les boulons fournis avec le kit qui sont de grade de 8.8 , ils auraient fallut qu'ils soient de grade 10.9 mais font le travail quand-même

This is a really good lift kit. Product came with all of tue necessary hardware. Installed it myself in an hour. Lift my truck as advertised. Quality product. We will see how long it lasts.

Put these on the front of my 2026 GMC Sierra 1500. Took about 2 hours to do both sides. The hardest part was separating the sway bar control rod since the stem just wants to spin and spin, but my truck is brand new and everything is still lubed pretty well. It may be easier on an older truck. Four-wheel drive also made it a little more difficult to tighten things down. My only gripe is that the bolts that came with the blocks had 16mm head and the nuts were 17mm. What the heck?

2024 GMC Sierra 1500 SLT Duramax X31. I used the 1.5" kit as I figured it would give a little more clearance for the cv shaft boots, these new T1 (2019 later) platform trucks don't have as much front droop as the previous GMT platform. First things first, mark your headlight positions with some masking tape ( mine was at about 25' away on garage wall) get you some 10mm bolts that are 10.9 instead of the 8.8 they send, you can use the nuts (make sure you get same pitch bolts) and washers, I pulled my truck up on ramps to drop the engine skid plate because it covers part of the front cross member. Down off the ramps, disconnected the negative battery cable (instead of messing with the wiring harness on the EPS unit), I figured its powered down so no issues. Jacked up with floor jack on front cross member, put 4 ton jack stands under the sway bar mount brackets let it down then put some pressure back on the floor jack. Tires off, took off the wheel speed sensor cable, tie rod ends off (pass thru ratchet makes it easier to take these and the sway bar mount bolts off and back on) even though this truck only has 800 miles on it the sway bar mount bolts spun with an impact wrench. I have a motorcycle jack which i put under the rotor to help support the weight when i dropped the top a arm and shock mount bolts. If you have a pry bar you can easily align and put the new FRONT shock mount bolts in without loosening the top strut bolts, once those are in the rears will pretty much align themselves with no issues. You will need to swing the a arm over quite a bit to get the new REAR bolts in the shock mount past the drive axle shaft ( Also did not take the drive axle nut off just be careful how you support the unit with the top a arm disconnected). Put everything back together, drove it about 5 miles to settle the front end, adjusted the headlights down (previously marked before project start). My end measurements were front 38" , rear 38-7/16", was just shy of a full 1-1/2" lift. No change in ride quality, doubt will have the front end aligned, I have done 2 previous GMC 1500's a 2015 and a 2018 and did not have them aligned and never had any issues, also done a 2008 and 2015 2500 HD's with the overclocked keys and transfer case spacers, the 2008 had the alignment check done, was not off far enough to even bother. Happy wrenching and be careful, you can hurt yourself if you don't have the proper equipment (using a floor jack with no jack stands, inadequate capacity floor jack, etc, etc).

Good price snd works as described.