Winters 2-1/2" Dial Size, Liquid Filled Industrial Pressure Gauge, Brass Internals, 304 Stainless Steel Case, Dual Scale 0-160 psi/kPa, 1.5% Acc, 1/4" NPT Back Mount, Glycerin Filled Pressure Gauge

Great construction. I have this in a piece of equipment that is ran approximately 70hrs a week. It’s outdoors and exposed to heat and vibration. It’s held up great for me so far!

These work well and are easy to install. Purchased to replace a couple of air compressor gauges that stopped working or filled with condensation. Needles jump all around in the stock gauges on gas driven air compressors. So Now when replacing gauges I look for glycerin filled over and others. Needle does not take a beating and the glycerin counter acts the condensation and extends the life of the gauge. Large 2 inch face is much easier to see from a distance than small stock gauges as well. Get your self some Teflon tape and you'll be up and running in minutes. These have been in service for about 22 months now on wheel barrow type compressors and the take what the guys can dish out on daily use compressors with no failures or issues to date, 10/10/2018. Update 08/31/20 Gauge holds up well, except when tools are dropped on them. We switched to these gauges after trying cheaper glycerin filled, which failed, and seal permitted glycerin to exit back of gauge and enter air tank and into the air system. Thanks Winter's and Amazon.

A good brand, and this is a fine gauge. So far.

Looks and feels of quality, clear numbering. Has a way of venting gases. Unclear if it does it's job or not.

Best gauges you'll fine for the money, very accurate too!! Highly recommended!!

Gauge works as it should

Accuracy guarantee, not so much. Perhaps my fault for getting liquid filled, but I expect that the gauge read correctly when vented per instructions. This gauge will not return to zero even with plug removed.

GOOD