Uniweld FB12 Flame Barrier, 12" x 12"

I use around plactic liners of refrigerator copper it works well and is moldable around to stay in place.

Pretty good product. If you use any water it will suck up the water. Also minded terabit when I wrapped it around a pipe. It did do the job however.

Product is thick and impossible to use in tight spots unless you cut a small part off. Product also separates from the backing after a few uses. I had high hopes for this as a replacement for the previous "black cloth" product I used but I will not be buying this again and would not recommend it for ongoing use. If the price was far less I would consider it for use in places with lots of room to solder and then dispose of it.

Easy to work with. Held firmly to the wood trim without causing damage to the paint. I used this tape to seal doorways when I had some flooring refinished. Kept the dust out

Works great. I ave made a few brazing already and it protected walls and wood around the pipe. And it does not smoke when heat is applied.

This stuff is great. Works just like they say. I use it for plumbing work.

The best product I tested with direct brazing flame

its got aluminum foil on one side of it ..come on and it's no where near like other Fire cloths DON'T BUY IT ...AND IT COST MORE THAN REAL FIRE CLOTHS..if it had pics of aluminum foil on one side of it would you buy it ..don't think so