Spal 30101522 12" Curved Blade Puller Fan

Like a lot of folks, I was experiencing performance issues with the cooling system in my turbo-charged 1988 CRX (D16A6). I have a Skunk2 Alpha half radiator, which is enough of an issue by itself since it holds less than a gallon of coolant, but then with the bumper and the intercooler in front of it, the cooling performance was substandard with the straight-blade Mishimoto fan I was running. Not only was this SPAL a perfect fit, it's extremely quiet and moves enough air that when it comes on you can feel the air moving with the hood closed from 6' away... great performance! Best yet, this fan fixed all my heat dissipation issues, quite happy with it!

Super thrilled with these fans! Last year I installed a set of cheap 80w fans that were claimed to pull 1400 cfm in my car. They had had such good reviews, but further analysis the next year showed that the reviewers didn't use them for their intended purpose. Turned out that the cheap 80w fans couldn't keep the car cool sitting in traffic on a 90* day without even running A/C. I switched to these fans this year and haven't looked back! These fans have much stronger motors than the cheap ones and suck tons of air through the radiator. I've used these with the A/C on and they have no problem keeping up! It's a night and day difference! I've added a few pictures of what these look like compared to the same size 80w fan I bought last year. Spal advises that it takes ~10 amps to draw 1000 cfm through a radiator. If that is true then that explains why these have been working so well for me! It would also mean that the 80w fans were likely pulling only ~666 cfm each.

Everyone recommends Spal fans for a reason. It’s no contest compared to cheap Chinese fans. Easily twice as much air in real world conditions.

I bought a $259 radiator 12" fan combo from alloyworks for my 6.0L swapped g body. Both fans failed within about a year, one won't turn on and one lost it's blade assembly. This 12" spal is slightly larger than the Chinese fan and required new holes to be drilled but fits nicely on the shroud. This spal fan looks to be far superior in quality and so far works great. Fan pulls 13.7 amps

Works great..

Did not install it yet but it solid good quality material

This fan moves A LOT OF AIR! It's a small hurricane powered by 12Volts of DC. Even though the fan moves large volume of air, it is not particularly noisy and the electric motor doesn't get uncomfortably hot. I use it in a stationary application when it sees many hours of continuous operation at full speed - much more than it would have experienced in a vehicle, and this fan runs without a hiccup. Rock solid!

Was having overheating issues with my k24 turbo swap at slow speeds and idle. It would reach 220* idling before I’d get scared and cut it off with Chinese ebay slim fan. I put this spal fan on with a dedicated relay harness using the factory fan plug as signal for relay and this thing pumps now. Gets to 196* idling for 45 mins and drops to 190* when I give it gas. Definitely a life saver and a necessity for any similar setups to what I have here! DO NOT MESS AROUND WITH THE CHINA JUNK GET THE SPAL AND STAY COOL!!

Well built and powerful. The Chinese Knock-off I had didn't come close to the output that it claimed, thus unable to do the job,so I replaced it with the Spal. What a difference. Now I have a Cool Car!

السلعه كانت جميله ... لاكن ليست هي ما ارغب بها شخصياُ

I installed it on my classic car, amazingly reduced the temperature to proper level constantly

المراوح اصليه و لكن البائع ارسل مقاسين مختلفين و بطريقه مخادعه مروحه مقاس 10 انش داخل صندوق 12 انش للتمويه